PPPoFR on multipoint interface question
Consider this simple setup:R1 102 ------ 201 R2 203 ------ 302 R3Here, PPPoFR is used to configure a common subnet 10.10.123.0/24 on R1, R2 & R3 with R2 being the hub. For each DLCI, it seems the...
View ArticleVPN Maps and Profiles
I'm a little confused about when and why to use different crypto elements. Can someone describe the evolution of static interface crypto maps to dynamic/static crypto profiles both for ISAKMP and...
View Article6.4
As ZBW/CBAC has been removed from v5 (and I dont intend to be taking the lab until July) I went with an ACL for this:ip access-list ex FILTERpermit icmp any any echo-replypermit icmp any any...
View Article4.1 L2 VC not comes up
Hi, I followed the SG and tunnel is up and I'm able to ping each others destination loo100 through tunnel int, also LDP neighbor comes up.However vc does not come up, my analysis says that label is not...
View Articlesomething I have noticed about the diff between wildcard and subnet
hi allsomething I have noticed about the different between wildcard address and the subnet mask address.regardless of the logic gates used,wildcard address is yes the inverse of subnet mask...
View ArticleASA pre 8.3 and 8.3+
Dears,I know that NAT differ between pre 8.3 and 8.3+ versions of Cisco ASA. Can i practice all other topics on a pre 8.3 ASA or there are other differences?Please advise,Moustapha
View ArticleCSC technology
Just started going through this and i can't shrug off the feeling that it is seems bit odd design in the real world, I would imagine most people would rather purchase a L2 service from the backbone...
View Articleme3600x qos enabled interface acting up
Hi everyone; just doscovered starnge issue. i am on a me 3600x. the client lan switch 9nexus 5k) is connected to gi0/1 on Me3600x. Customer has subscribed to a 300 meg wan service. wan interface...
View Article5.1 / 5.2
I used BSR for my PIM setup without issue (I noticed when looking at the PIM interfaces, they were all configured as sparse, so figured it saved me having to go around setting up pim rp addresses...
View ArticleVRF LITE
Just to confirm what i think.... is it possible to use some trick to do inter VRF routing locally on same router by using only static routes?I mean we have 2 routers, R1-R2 for example, connected by...
View Article7.38 BGP Communities - No-Export
Hi,I have done this task and checked my configuration, but when I do the same verification as in the workbook I don't get the same results.The "Rack1R3#show ip bgp nei 155.1.13.1 advertised-routes"...
View ArticleShould I follow INE's CCNA 640-802 for New CCNAX 2.0?
Dear INE's members,Does INE's CCNA 640-802 still support the new CCNA 200-120? Thank you Kindest regards,Vannara Mao
View ArticleTask 1.3 Alternative Solution
ip dhcp snooping vlan 5ip dhcp snoopingip source binding 0000.0C12.3456 vlan 5 167.1.5.5 interface Fa0/5 interface FastEthernet0/5 switchport access vlan 5 switchport mode access switchport...
View ArticleTASK 8.2
Hi, In task 8.2, it says configure R1 not send ...... out this interface.Why won't we use traffic shaping? thx
View ArticleHow to bloc youtube with my cisco rotuer ?
"Hi, can someone help me. i want to know if i can be able to bloc youtube with cisco router 2921/k9 ?" This is most cisco useres want to know recently. If you want to know the answer or also have this...
View ArticleOSPF really is Distance Vector (between Areas)
Before today I undestood that between Areas we lose the detailed OSPF database that fully describes all the links and routers in the Area allowing each router to fully construct a topology and compute...
View Article2.3 RIP Filtering
I don't believe the SG answer is correct for this task. I entered verbatim what the SG has and the 31.x.x.x routes from BB3 all show up.RSRack26SW1#show ip route rip 132.26.0.0/16 is variably...
View ArticleQuestions about workbooks and racks
Hi , I have the following few questions which i hope you answer: 1- I saw that the workbook for v4 seems to be available at http://www.ine.com/self-paced/ccie-security/workbooks.htm , can you confirm...
View ArticleL2 VPN's vs L3VPN's
I'm trying to understand what kind of L2 VPN's and L3 VPN's there are, and what there advantages are over the other I'm hearing and seeing a lot of variants on the internet and I'm trying to keep them...
View ArticleDifference between Cisco C3750X-48P-L and C3750X-48P-S ?
what is the differance between the WS-C3750X-48P-L and the WS-C3750X-48P-S also do these all include a smartnet?
View Article