I need some assistance with this if someone can tell what I did wrong based off the outputs. I checked my configurations against the FCOE lab in the workbook and everything appeared to be spot on. I got all of my interfaces up and working and saw the servers and SANs register to the fabric. The only thing is when I went to One Command on the emulex server, to see if the LUNs appeared, they did not and the server was enabled to discover any targets out there. Also since this was a Nexus 5000 I did not change any QOS policies as the book did not advise that this was a requirement. If someone can provide some insight so that I'll know for next time, that will be great. Thanks!
MDS3(config-vsan-db)# sho fcns da
VSAN 101:
--------------------------------------------------------------------------
FCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE
--------------------------------------------------------------------------
0xea0000 N 10:00:00:00:c9:bb:19:9f (Emulex) ipfc scsi-fcp:init
0xeb0000 N 21:00:00:1b:32:07:32:23
0xeb0100 N 21:01:00:1b:32:27:32:23
N5K3(config)# sho fcns da
VSAN 101:
--------------------------------------------------------------------------
FCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE
--------------------------------------------------------------------------
0xea0000 N 10:00:00:00:c9:bb:19:9f (Emulex) ipfc scsi-fcp:init
0xeb0000 N 21:00:00:1b:32:07:32:23 (Qlogic)
0xeb0100 N 21:01:00:1b:32:27:32:23 (Qlogic)
N5K3(config)# sho int vfc 111
vfc111 is trunking
Bound interface is Ethernet103/1/1
Hardware is Ethernet
Port WWN is 20:6e:00:0d:ec:a4:51:7f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is TF
Port vsan is 101
Trunk vsans (admin allowed and active) (101)
Trunk vsans (up) (101)
Trunk vsans (isolated) ()
Trunk vsans (initializing) ()
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
932355323 frames input, 0 bytes
0 discards, 0 errors
525416120 frames output, 496355986892 bytes
0 discards, 0 errors
last clearing of "show interface" counters Wed Jul 24 10:41:28 2013
Interface last changed at Thu Sep 5 16:11:58 2013
interface Ethernet103/1/1
switchport mode trunk
switchport trunk native vlan 10
switchport trunk allowed vlan 10,1101
spanning-tree port type edge trunk
N5K4(config)#
VSAN 102:
--------------------------------------------------------------------------
FCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE
--------------------------------------------------------------------------
0x360000 N 10:00:00:00:c9:bb:19:a3 (Emulex) ipfc scsi-fcp:init
0x400000 N 21:02:00:1b:32:47:32:23 (Qlogic)
0x400100 N 21:03:00:1b:32:67:32:23 (Qlogic)
Total number of entries = 3