logical topology and other question
hello my friend ....this is naif from Saudi Arabia on member of ine.comi want to describe to me how the logical topology looks like .i want to understand for exa vlan 146 related to R1 and all vlan in...
View ArticleCCIE Security ATC videos...
By when can we purchase the new CCIE Security V4 Advanced Technology Class videos... the workbook I guess is already available...??? Regards,Sharat
View ArticleTask 2.1 - IOS Behavioral Issue??
I was running IOS 12.4(24)T8 on all of my IOS devices (thinking newest is best); but, after watching INE's advanced troubleshooting vSeminar, Brian Dennis specifically states about 5-10 minutes into...
View ArticleDropping packets
I have a scenario of dropping packets in my class-default class under a specified policy-map (outbound) and I can't figure out why. The priority and other defined classes don't get near their assigned...
View ArticleIKEv2 Workbook n ATC
Hey Chris,I dont see where IKEv2 is covered in the workbooks. Will this be in the ATC video?
View ArticleClik here to view.
Why does my PBR does not work with OSPF P2M Network Type?
R5(config)#! On R5 I am filtering route to R2's loopback: 150.1.2.2/32R5(config)#! inbound, so Type 1 LSA still exists in R5's databaseR5(config)#!but not in the routing table, let's seeR5(config)#do...
View ArticleRack Rental - CM issue
I'm in the middle of a lab and for some reason the phones (I'm using the diagram from Voice Rack Rental) at the Corp site shows "unknown" both at the registration and IP level. I had this same problem...
View Article3.4 Floating Static Routes
HiAm just curious about the solution provided to this question. I can understand why one would configure an Admin Distance of 20 after the "less preferred" route in order to ensure that the preferred...
View ArticleAuto RP filters
I can't figure out why when using auto rp if I add rp announce filters with group filters on the rps the solution works. If I remove the group filters from the RPs with the announce filters the...
View ArticleEnhanced VPC with oprhaned ports
HI I would like to understand with enhanced vpc does this stop the oprhaned ports issue AS the FEx are dual homed to the a pair of 5k in the old fex design where it it was only connected to the one...
View Articlemsdp multicast
do we use msdp to peer RPs that are in different AS or do we use it for RPs that are in same as well?
View ArticleBGP Route-Map Logic
Hi,Just wanted to share a drawing I made explaining BGP Route-Map Logic:http://ds.piecesofart.net/ieoc.com/BGP%20Route-Map%20Logic.pngI would love to hear your comments / suggestions.Thanks!
View ArticleFRTS question
I am little confused on when and how to use the "frame-relay traffic-shaping" command. I is my understanding that it should be used when you want to enable legacy FRTS only like the config below. It...
View ArticleTask 7.14 Next Hop (Route-Map) on R3 ..?
Dears,I have seen that we point Next-Hop to R1 in Router#3.If we do not do it , packet go to SW1 and dont reach.In normal cases/previous Tasks we always do next-hop self on Border Routers and in...
View Article5.26 EIGRP Filtering with Route Maps
[omitted]* Configure a route-map filter on R3 that denies EIGRP routes with a metric in the range of 500,000 - 750,000 from entering the routing table.* These filters should no impact any other...
View Article7.13 BGP over GRE
I'm sure I'm missing something relatively simple, but for the peering between R2 and R4, why can't we peer (or why can't I get them to peer? over the FR cloud? Using 155.x.0.2 and 155.x.0.4 as the...
View ArticleNexus 7K Design utilizing F2 modules
We are currently looking at the Nexus line for a data center migration project, hence looking a the overall design, and as we all know the Nexus line isn't a cheap purchase. Anyway, I'm reviewing the...
View Article1.42 - Command not showing up
Hi All,My question is regarding 1.42's final task - Configure port Fa0/6 with an access VLAN assignment of 146, and for voice VLAN frames to use dot1p tagging.I put the dot1p command in, but it doesn't...
View Article