When I did the ISCSI task in Nexus, I couldn't see the ISCSI drive in My Computer. Iscsi not showing in My computer although can see the target and connect to it ( i.e.,it pulls the target qualified name) in the Iscsi initiator program. Also , ISCSI stats are not very high as the gig interface corresponding to it? Is this normal? Why can't I see the drive when in the Iscsi program can see the target.Any clues where I might be going wron?
MDS4# sh iscsi stats iscsi 1/1
iscsi1/1
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
iSCSI statistics
52 packets input, 5756 bytes
Command 30 pdus, Data-out 0 pdus, 0 bytes, unsolicited 0 bytes
output 52 packets, 4436 bytes
Response 30 pdus (with sense 3), R2T 0 pdus
Data-in 27 pdus, 972 bytes
MDS4# sh int gi1/1 | in rate
5 minutes input rate 55744 bits/sec, 6968 bytes/sec, 1 frames/sec
5 minutes output rate 55600 bits/sec, 6950 bytes/sec, 1 frames/sec