Working on lab10 in V2 workbook. My exam is in 19 days and I am trying to focus in on details of the task. To me this task sounds like it wants me to setup 5:1 UCLB for traffic destined to the 164.x.26.0/24 network. I configured an offset list for only that network (didn't say you couldnt use offset list). But in the solutions it uses delay to get to correct ratio. I understand that these are both viable solutions, but my solution only sets the 5:1 ratio for the 164.x.26.0/24 network. The other networks learned over these two links (ie 150.x.6.0/24) are balanced based on default calcualted metrics. Am I overthinking the task?
2.1 EIGRP Load Distribution
- One of the deciding factors in choosing EIGRP as an IGP in your network was the ability to do unequal cost load balancing. Therefore, your network design specification dictates that all traffic from hosts on VLAN 18 destined for hosts on VLAN 26 be load balanced across all links in the transit path.
- Assume that the Frame Relay circuit between R1 and R2 is provisioned at 256Kbps, the circuit between R2 and R3 is provisioned at 1.28Mbps, and the PPP link between R1 and R3 is a full T1 of 1.536Mbps.
- Configure your network so that R1 distributes traffic between R3 and R2 in a ratio of 5:1, respectively.
3 Points