Dear Gents,
After completing the 4.15 task I am unable to see the route of R3 Lo0 from R6 and also in R6 is not geetting update .
Here is the Partial out put of R6:
150.1.0.0/24 is subnetted, 8 subnets
R 150.1.7.0 [120/1] via 155.1.67.7, 00:00:04, FastEthernet0/0.67
R 150.1.5.0 [120/3] via 155.1.67.7, 00:00:08, FastEthernet0/0.67
R 150.1.4.0 [120/4] via 155.1.67.7, 00:00:08, FastEthernet0/0.67
R 150.1.2.0 [120/4] via 155.1.67.7, 00:00:00, FastEthernet0/0.67
R 150.1.1.0 [120/3] via 155.1.67.7, 00:00:00, FastEthernet0/0.67
R 150.1.9.0 [120/2] via 155.1.67.7, 00:00:00, FastEthernet0/0.67
R 150.1.8.0 [120/4] via 155.1.67.7, 00:00:00, FastEthernet0/0.67
Rack1R6#sh ip protocols
Routing Protocol is "rip"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Sending updates every 10 seconds, next due in 6 seconds
Invalid after 60 seconds, hold down 60, flushed after 80
Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Recv Triggered RIP Key-chain
FastEthernet0/0.67 2 2
FastEthernet0/0.146 2 2 R1_R6
Serial0/1/0 2 2
Loopback0 2 2
Automatic network summarization is not in effect
Maximum path: 4
Routing for Networks:
54.0.0.0
150.1.0.0
155.1.0.0
Routing Information Sources:
Gateway Distance Last Update
54.1.1.254 120 00:00:05
155.1.67.9 120 00:24:29
155.1.67.7 120 00:00:00
Out put from SW1-Partial:
150.1.0.0/16 is variably subnetted, 9 subnets, 2 masks
R 150.1.1.0/24 [120/2] via 155.1.37.3, 00:00:07, FastEthernet0/3
R 150.1.2.0/24 [120/3] via 155.1.37.3, 00:00:07, FastEthernet0/3
R 150.1.4.0/24 [120/3] via 155.1.37.3, 00:00:07, FastEthernet0/3
R 150.1.5.0/24 [120/2] via 155.1.37.3, 00:00:07, FastEthernet0/3
R 150.1.6.0/24 [120/1] via 155.1.67.6, 00:00:06, Vlan67
R 150.1.8.0/24 [120/3] via 155.1.37.3, 00:00:07, FastEthernet0/3
R 150.1.9.0/24 [120/1] via 155.1.79.9, 00:00:07, Vlan79
Rack1SW1#sh ip protocols
*** IP Routing is NSF aware ***
Routing Protocol is "rip"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Outgoing routes in Vlan79 will have 15 added to metric if on list 1
Sending updates every 10 seconds, next due in 8 seconds
Invalid after 60 seconds, hold down 60, flushed after 80
Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Recv Triggered RIP Key-chain
Vlan7 2 2
Vlan67 2 2
Vlan79 2 2
FastEthernet0/3 2 2
Loopback0 2 2
Automatic network summarization is not in effect
Maximum path: 4
Routing for Networks:
150.1.0.0
155.1.0.0
Routing Information Sources:
Gateway Distance Last Update
155.1.37.3 255 00:00:03
155.1.67.9 120 00:26:29
155.1.79.9 120 00:00:02
155.1.67.6 120 00:00:01
Distance: (default is 120)
Address Wild mask Distance List
155.1.37.3 0.0.0.0 255 10
I already clear the route but not able to receive from R6.
Thanks