Hi, can anyone tell me why my physical ports on my IOM/FEX modules are showing as 'up' when nothing is plugged into them?
I have 2104XP IOM's and only ports 1 and 2 have connections. But when I look in nxos, I see 1/1/3 and 1/1/4 as 'up':
--------------------------------------------------------------------------------
Ethernet VLAN Type Mode Status Reason Speed Port
Interface Ch #
--------------------------------------------------------------------------------
Eth1/1/1 1 eth vntag up none 10G(D) --
Eth1/1/2 1 eth vntag up none 10G(D) --
Eth1/1/3 1 eth trunk up none 10G(D) --
Eth1/1/4 1 eth vntag up none 10G(D) --
Eth1/1/5 1 eth access down Administratively down 10G(D) --
Eth1/1/6 1 eth access down Administratively down 10G(D) --
Eth1/1/7 1 eth access down Administratively down 10G(D) --
Eth1/1/8 1 eth access down Administratively down 10G(D) --
Eth1/1/9 1 eth trunk up none 10G(D) --
ITSLAB-UCS01-A(nxos)#
Now I'm assuming e1/1/9 is the cmc connection, and 1/1/1-1/1/4 are my physical external connections. E1/1/5 - E1/1/8 do not actually exist, as it's only a 2104.
Also, not sure why E1/1/3 shows as 'trunk' and not 'vntag'??