hello to every one this is my first post in this forum i hope help me.
i have 4 sites that are connected via ospf in backbone. all i to do in each site is to configure my gig0/1 an ip address and put it on OSPF area 0 and then i can ping my sites and all 4 sites have full reachability to each other. (the pic is available. and all routers are cisco 2911).
gig 0/0 is connected to an especial device that it is IPX-based. i already implemented a point-to-point L2tvp3 between 2 sites and both sites can see the IPX. but i want all sites can see IPX and as you see i must implemet VPLS but my routers doesnt support it. and i found a document in Cisco contaning Routed- Pseudowire .
i want to know can i implement Routed- Pseudowire to do my task? actuallu each site in a specific VLAN and all sites can see IPX? or it is not possible?
regards
