Task 2.6
Hey guys, I would to know if there is only way to do this task below: Part of the acquisition agreement between AS 400 and AS 100 stipulates that AS 400 will not provide transit for traffic coming from...
View ArticleISIS as PE-CE routing protocol routing loops
I decided to use ISIS as my PE-CE routing protocol during a lab and found that I can easily introduce a loop into ISIS, without a backdoor link or anyting too complex! +-----+...
View ArticleMulticast problem - Dense mode over Frame and Multicast Stub
I am having a problem with multicast packets not being delivered accorss a Fram connection. It works ok if I remove the Multicast Stub config, BB2--R3---R1--(FRAME)--R5--CLIENT The traffic is being...
View ArticleAnyconnect on ASA
Hi,I wanted to know when Anyconnect connects to the ASA, does it perform CRL (Certificate Revocation List) check?
View ArticleIdentity NAT
I’m a bit confused about Identity NAT and NAT exemption on ASA. Both of these use NAT 0, then how they are different? Which one we’ve to use over S-2-S VPN traffic?
View ArticlePackets not getting encap
Hi, I have a cisco 1841 having some vpn issues.. Currently I have a Site to site vpn working fineBut the "VPN Server config " I am using so i can vpn into the cisco box does not seem to work.. im not...
View ArticleDan Ameme - CCIE #40008
I'm happy that I finally get to write my success story :-)The story of my first attempt belowhttp://ieoc.com/forums/p/24377/186185.aspx#186185After my first failed attempt, I had a very good idea about...
View ArticleInitial Config - Volumn II
Hi,i am starting Lab I in Volumn II and notice the initial config is missing some info. I am not sure this was done in purpose or I have a bad copy of the initial config. For example, Task 2.1 OSPF,...
View ArticleINE Strikes again....CCIE #40255
Well, It took me two goes around, but I did it. I sat my Lab yesterday and received the dreaded email at 4:21am this morning. About two hours ago actually, im too excited to go back to sleep. After my...
View Article7.2 RMON
Hi,Would you consider the following config valid for R1 as well ? rmon event 2 log description "Over Utilization" rmon event 3 log description "Normal Utilization"rmon alarm 1 ifEntry10.3 60 delta...
View ArticleMPLS 101 - Missing something
Hi all I am having a problem understanding an issue I have and in particular the verification of the issue. The setup I have is based on the INE R&S topology but I have constructed a diagram which...
View ArticleTask 2.4 - RIP redistribution?
Hi everyone, was I the only one confused by this task?Here is the statement:- redistribute VLAN 32 into RIP on R3- Redistribute between OSPF and RIP on R3- All routers in the ospf domain should have a...
View Article4.11 Redistribution and Loop Prevention
Can someone explain why SW1 needs to lower distance on RIP? I don't see any other boundary router between this RIP domain and the OSPF domain. My lab session is fixing to end, so I may try to lab...
View ArticleIPv6 multicast address.
Hi Guys, I have a query regarding IPv6 multicast address.R1#sh ipv6 int fa0/0FastEthernet0/0 is up, line protocol is up IPv6 is enabled, link-local address is FE80::CE03:CFF:FE98:0 Global unicast...
View ArticleFull Scale Lab 4 task 4.1 errors on workbook
Here is what the lab asks for in 4.1: 4.1 VPNv4 Unicast BGP• Configure VPNv4 Unicast iBGP peerings in AS 1000 between R2 & XR2, R5 & XR2,and XR1 & XR2.• Configure IPv6 Unicast iBGP peerings...
View ArticleCisco IOS IPS
Hello,I am running IOS IPS on a few routers that are internet facing. Is there a set of signatures that deal with internet facing devices? Of the 5000 or so signatures, I do not not need many of them,...
View ArticleFrame-relay sub-interfaces will not come UP
There is a Headquarters router , a Branch1 router, and a Branch2 router connected to a 1760 Frame-Relay switch. Clocking is configured on the Frame-Relay switch, however, I cannot get the serial...
View ArticleTask 3.15 - Use of OER-MAP
Why does the solution use match ip address instead of match traffic class when the question states to use a prefix traffic class for 112.0.0.0/24?
View ArticleMAB
What is the MAB feature and how is it different from the standard 802.1x authentication? What are the important things to consider while configuring and implementing it?Thanks,Rajnish
View ArticleIOS-XR LDP label weirdness
I'm doing Full Scale Lab 4 and found something strange:routes---XR1------XR2Both XR1 and XR2 are peering via ISIS and LDP via their POS interface.XR1 is doing redistribution of some routes from BGP...
View Article