BGP Path selection question
Hi all,From the following output why is the second path best?R5#sh ip bgp 114.0.0.0BGP routing table entry for 114.0.0.0/8, version 6Paths: (2 available, best #2, table default) Advertised to...
View ArticleSummary address with specific route in OSPF
Hi All, I want to configure ospf so that it can send summary with some specific route same as in BGP. R1-R2-R3 There is OSPF between R1 and R2 and Eigrp between R2 and R3. I can do it with EIGRP leak...
View ArticleNAT ALG, v5 blueprint
Hello everyone, I was wondering if anyone has any information on NAT ALG (examples, tutorials... ), I see this topic is on v5 blueprint.Not sure what we could be tested on regarding that topics, and...
View ArticleProblem with disks on dcrack5
Hello guys, I hope anyone can help me, i'm having problems with bot FC, FCoE, iSCSI and FCIP on dcrack5.I'v set up the labs according to the workbook, but i can't see any disks on the servers, i can...
View ArticlePUTTY keepalive is echoing "q"
Using putty on a new setup, and the keepalive is echoing the letter "q".I am sure that this is it, because if I lower the keepalive to 2 seconds, the echo matches.It is kind of disruptive, especially...
View ArticleLong fail report - CCIE RS - Sao_Paulo
Hello friends,So I got my test results exactly 2 hours after its end. Kinda weird...My official CCIE number is "Not Certified".This is my 2nd attempt, previous one was in October, last year.I was ready...
View ArticleIGMP proxy
Hi,When would the IGMP proxy feature be used. If a router does not have support for IGMP(PIM)? Is it something that we should know for the lab. Look at this...
View ArticleHow to schedule INE SP Mock Lab ?
DaersAppologize for asking the basic stuffDoes INE offer Mock lab for SP track ? If it does, how to book it ?Regards
View ArticleIssue with GNS3 Beta release....
I just downloaded the Beta1 release of the new GNS3. In the previous Alpha releases, I never had the problem I'm going to describe below. When I use a c7200 router and connect to an ethernet switch I...
View ArticleAutomate Loading of Advanced Tech labs
So each lab in each section now has its own config to be loaded. Its getting very time consuming to blow back to a base config on all 10 devices and then load the needed configs. Here is what I do now....
View ArticleWhat’s the Correct use of the term Pseudo-wire when referring to AToM/L2TPv3...
Hello,I need someone to clarify the use of the term pseudo-wire. Is it true that when some one is using the term pseudo-wire they are referring to either an AToM or L2TPv3 instance for the VPWS family?...
View ArticleEIGRP Calculation
Hi All, I'm struggling to understand the formula properly. What I don't understand is the BW calculation within the formula. So the EIGRP BW is "Inverse lowest BW along a path in Kbps scaled by 10^7...
View ArticleIKEv1 L2L Between IOS Routers with ISAKMP Profile
Question on this lab. Is there a reason why we wouldn't set the proxy identity on R1 in the dynamic crypto map? If we dont set the proxy idenetity using the match address ACL_NAME command we cannot...
View Articleservers use by single public ip address in firewall
hello everyoneI have 30 servers which is connect to the inside interface of firewall and only one public ip address on outside interface. how can use this servers from outside(internet) using single...
View ArticleWSA Redundancy
Hello group, It seems there’s no redundancy concept on the WSAs, at least it’s what I understand from the documentation. Taking as true the above sentence, if I want some kind of redundancy I need to...
View ArticleClik here to view.
Can we use Network id in below scenario?
Dear All, Can I assign my cache [J5K] with a Network ID in below scenario ? as I have /30 only for the connectivity.
View ArticleLayer 2 EtherChannel with PAgP
HiI was doing lab on RS5 Layer 2 EtherChannel with PAgP and in the workbook it says configure the po12,13,14 with switchport trunk encapsulation dot1q and switchport mode dynamic desirable and other...
View ArticleIKEv1 L2L Between IOS Routers with ISAKMP Profile
Regarding the task: R2 should establish the VPN tunnel only if the peer's certificate issuer equals R1.ine.com.To meet this requirement, On R2, i need to apply "certificate-map" at the "trustpoint"...
View ArticleIKEv1 L2L Between IOS and ASA with PSK in Aggressive Mode
I have a question. Does anyone able to make this to work using SG solution?I seem can't get the vpn to come up using SG solution. Got below error message on asa:"[IKEv1]Group = 192.168.70.22, IP =...
View ArticleSeat for CCIE SP
Greetings,I'm aiming to have my lab exam in february in Sao Paulo, however there is no seat avaliable for there. Does anyone have passed for any similar experience before?If I can't book a seat in Sao...
View Article