I'm unable to ping 224.10.10.10 from R6, R5, R4. could you guys help?
R4:
ip multicast-routing
ip pim rp-address 150.1.5.5
!
interface FastEthernet 0/1
ip pim sparse-mode
!
interface Serial 0/1
ip pim sparse-mode
!
interface Serial 0/0.1
no ip pim dense-mode
R5:
no ip mroute 0.0.0.0 0.0.0.0 155.1.0.4
!
ip multicast-routing
ip pim rp-address 150.1.5.5
!
interface Serial 0/1
ip pim sparse-mode
!
interface Serial 0/0
no ip pim dense-mode
!
interface FastEthernet 0/0
ip pim sparse-mode
!
! Needed to fix RPF check for R5’s Loopback0
!
interface Loopback0
ip ospf network point-to-point
R6:
ip multicast-routing
ip pim rp-address 150.1.5.5
!
interface FastEthernet 0/0.146
ip pim sparse-mode
SW2:
ip multicast-routing distributed
ip pim rp-address 150.1.5.5
!
interface Vlan 58
ip pim sparse-mode
!
interface Port-Channel1
ip pim sparse-mode
SW4:
ip multicast-routing
ip pim rp-address 150.1.5.5
ip pim spt-threshold 128
!
interface Port-Channel1
ip pim sparse-mode
!
interface Vlan 10
ip igmp join-group 224.10.10.10
ip pim sparse-mode
R4#sh ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.10.10.10), 00:03:10/stopped, RP 150.1.5.5, flags: SPF
Incoming interface: Serial0/1, RPF nbr 155.1.45.5
Outgoing interface list: Null
(155.1.45.5, 224.10.10.10), 00:02:07/00:00:54, flags: PFT
Incoming interface: Serial0/1, RPF nbr 155.1.45.5
Outgoing interface list: Null
(155.1.146.6, 224.10.10.10), 00:03:10/00:03:22, flags: T
Incoming interface: FastEthernet0/1, RPF nbr 155.1.146.6
Outgoing interface list:
Serial0/1, Forward/Sparse, 00:03:11/00:03:19
(*, 224.0.1.40), 00:11:39/00:02:47, RP 150.1.5.5, flags: SJCL
Incoming interface: Serial0/1, RPF nbr 155.1.45.5
Outgoing interface list:
FastEthernet0/1, Forward/Sparse, 00:03:37/00:02:47
R4#ping 224.10.10.10
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 224.10.10.10, timeout is 2 seconds:
.
R5#sh ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.10.10.10), 00:01:42/stopped, RP 150.1.5.5, flags: S
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
FastEthernet0/0, Forward/Sparse, 00:01:42/00:02:47
(155.1.146.6, 224.10.10.10), 00:00:22/00:02:37, flags:
Incoming interface: Serial0/1, RPF nbr 155.1.45.4
Outgoing interface list:
FastEthernet0/0, Forward/Sparse, 00:00:22/00:02:37
(*, 224.0.1.40), 00:08:50/00:02:53, RP 150.1.5.5, flags: SJCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Serial0/1, Forward/Sparse, 00:00:50/00:02:58
FastEthernet0/0, Forward/Sparse, 00:08:50/00:03:22
R5#
R5#ping 224.10.10.10
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 224.10.10.10, timeout is 2 seconds:
.
R5#ping 224.10.10.10
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 224.10.10.10, timeout is 2 seconds:
.
R5#
R6#ping 224.10.10.10
Type escape sequence to abort.
Sending 1, 100-byte ICMP Echos to 224.10.10.10, timeout is 2 seconds:
.
R6#
R6#
R6#sh ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.10.10.10), 00:07:06/00:02:22, RP 150.1.5.5, flags: SPF
Incoming interface: FastEthernet0/0.146, RPF nbr 155.1.146.4
Outgoing interface list: Null
(*, 224.0.1.40), 00:15:29/00:02:08, RP 150.1.5.5, flags: SJPCL
Incoming interface: FastEthernet0/0.146, RPF nbr 155.1.146.4
Outgoing interface list: Null
SW2#sh ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
V - RD & Vector, v - Vector
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.10.10.10), 00:09:32/00:03:24, RP 150.1.5.5, flags: SF
Incoming interface: Vlan58, RPF nbr 155.1.58.5
Outgoing interface list:
Port-channel1, Forward/Sparse, 00:09:32/00:02:48
(155.1.58.5, 224.10.10.10), 00:00:11/00:02:48, flags: FT
Incoming interface: Vlan58, RPF nbr 0.0.0.0
Outgoing interface list:
Port-channel1, Forward/Sparse, 00:00:11/00:02:48
(155.1.108.8, 224.10.10.10), 00:00:21/00:03:08, flags: T
Incoming interface: Port-channel1, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan58, Forward/Sparse, 00:00:21/00:03:08
(155.1.58.8, 224.10.10.10), 00:00:21/00:02:38, flags: FT
Incoming interface: Vlan58, RPF nbr 0.0.0.0
Outgoing interface list:
Port-channel1, Forward/Sparse, 00:00:21/00:02:38
(*, 224.0.1.40), 03:43:59/00:02:51, RP 150.1.5.5, flags: SJCL
Incoming interface: Vlan58, RPF nbr 155.1.58.5
Outgoing interface list:
Port-channel1, Forward/Sparse, 00:09:39/00:02:37
SW2#
SW4#sh ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
V - RD & Vector, v - Vector
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode
(*, 224.10.10.10), 03:42:44/00:02:58, RP 150.1.5.5, flags: SCL
Incoming interface: Port-channel1, RPF nbr 155.1.108.8
Outgoing interface list:
Vlan10, Forward/Sparse, 03:42:44/00:02:16
(*, 224.0.1.40), 03:42:44/00:02:58, RP 150.1.5.5, flags: SPCL
Incoming interface: Port-channel1, RPF nbr 155.1.108.8
Outgoing interface list: Null