I was working through the new v5 L2 Labs and got down to the smartport macro lab and found that I was unable to create a smartport macro. I know I have created them before on older version of IOS, but was unable to create one on any of the switches I had access to. I was using INE's v5 Rack Rental.
In global config, when I would type the work "Macro", I would only get two options: Auto and Global
SW1(config)#macro ?
auto Macro autoexecution settings
global Enter global macro configuration
Here is the show version from the switch I was on:
SW1(config)#do sh ver
Cisco IOS Software, C3560 Software (C3560-IPSERVICESK9-M), Version 15.0(2)SE, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Sat 28-Jul-12 00:01 by prod_rel_team
ROM: Bootstrap program is C3560 boot loader
BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)
SW1 uptime is 1 hour, 50 minutes
System returned to ROM by power-on
System image file is "flash:/c3560-ipservicesk9-mz.150-2.SE.bin"
Is this something Silly I am forgetting to do or not creating the macro in the right place? its getting late and I have been labing for quite a while so it is very possible my brain is just jello :-)