Hi,
Working on task 3.1, I have assigned the networks 2002:96XX:Y0Y:3456::/64 to the VLans 3, 4, 5 and 6.
SG assigned the networks to Tunnel intefaces. Of source the 6to4 tunnels will still work, but this configuration will not allow the vlans above to communicate with each other.
Moreover SG already assumes that the management PC located in Vlan 6 has the IP 2002:9601:606:1:0209:6BFF:FE06:47EF which means that R6's f0/0 should have the IPv6 address of 2002:9601:606:3456::6 rather than R6's Tun3456 interface.
Assiging 2002:96XX:Y0Y:3456::/64 to the VLans 3, 4, 5 and 6 and enabling IPv6 on tunnel interfaces with the command "IPv6 enable" is the correct solution.
What do you think?
↧
3.1 IPv6 Features
↧