I configured CorpHQ, Branch1, & Branch2 with identical RSVP & MTP configurations in both the gateway & CUCM, however, when I attempt to make calls to/from Branch2, I get a NOT ENOUGH BANDWIDTH error. Calls beweeen CorpHQ & Branch1 work fine. On the CUCM, I configured REGIONS, DEVICE POOLS, LOCATIONS, SRST REFERENCES, MTPs, MRGs, and MRGLs for all 3 locations. Below is the configuration for all 3 gateways.
Thanks,
BRANCH2#
interface Serial0/1/0.1 point-to-point
description == FR To HQ
ip address 177.0.201.2 255.255.255.0
ip pim dense-mode
snmp trap link-status
frame-relay interface-dlci 102
ip rsvp bandwidth 136
!
sccp local Loopback0
sccp ccm 177.1.254.3 identifier 3 priority 3 version 5.0.1
sccp ccm 177.1.10.10 identifier 1 priority 1 version 5.0.1
sccp ccm 177.1.10.20 identifier 2 priority 2 version 5.0.1
sccp
!
sccp ccm group 1
bind interface Loopback0
associate ccm 2 priority 1
associate ccm 1 priority 2
associate ccm 3 priority 3
associate profile 1 register Br2-729-MTP
associate profile 2 register Br2-711-MTP
!
dspfarm profile 1 mtp
codec g729ar8
codec g729r8
rsvp
maximum sessions software 10
associate application SCCP
!
dspfarm profile 2 mtp
codec g711ulaw
rsvp
maximum sessions software 10
associate application SCCP